To learn more about how we can best support the needs of our customers and partners, we will be attending the Los Angeles Lit & Toy Show and related Porsche week events from 2/24/2026 - 3/1/2026.

Orders during this time will be packed and shipped starting the week of 3/2/2026. Apologies for any inconvenience.

Hall Effect Crank Sensor - 1/2"

1/2 Hall crank sensor with 36" leads and mating connector

4 Wires:

  • Red - 12V power
  • White - Sensor signal
  • Black - Sensor ground
  • Bare or Green - Shield

Air gap to trigger wheel: 0.030" - 0.035" (~0.9 mm)

 

Hall effect crank sensors are superior to magnetic sensors at slow cranking speeds and better resist starter motor related electrical noise issues.

This hall sensor is compatible with Electromotive's TEC-s, TEC-s200, TEC-gt, TEC-gt200 and TEC-3r engine management systems and the XDi-2 and XDi200 Ignition systems.

The hall sensor fits the same brackets as the 1/2" magnetic sensor.  Simply install the new hall sensor as you would a magnetic sensor and attach the 3 pin connector to the existing wire harness.  Attach the included yellow wire to switched ignition.  In the engine program file, go to advanced settings and change the crank sensor to 'Hall'.  Save the file and program the ECU.

Conversion complete.

 

Formerly P/N 75000

$165.00

Add to Cart:
  • Model: 7002-05
Ask a Question