Hall Effect Crank Sensor - 1/2"

1/2 Hall crank sensor with 36" leads and mating connector

4 Wires:

Red - 12V power
White - Sensor signal
Black - Sensor ground
Bare or Green - Shield

Air gap to trigger wheel: 0.030" - 0.035" (~0.9 mm)

Hall effect crank sensors are superior to magnetic sensors at slow cranking speeds and better resist starter motor related electrical noise issues.

This hall sensor is compatible with Electromotive's TEC-s, TEC-s200, TEC-gt, TEC-gt200 and TEC-3r engine management systems and the XDi-2 and XDi200 Ignition systems.

The hall sensor fits the same brackets as the 1/2" magnetic sensor. Simply install the new hall sensor as you would a magnetic sensor and attach the 3 pin connector to the existing wire harness. Attach the included yellow wire to switched ignition. In the engine program file, go to advanced settings and change the crank sensor to 'Hall'. Save the file and program the ECU.

Conversion complete.

Formerly P/N 75000

Write Review